NVIDIA® Jetson™ Linux requires a root file system. You must create a Linux host system and copy it to your reference board.
Sample Root File System
NVIDIA Jetson Linux Driver Package (L4T) comes with a pre-built sample root file system created for the NVIDIA Jetson Developer Kit. If you wish to create an Ubuntu sample root file system, see:
The sample root file system is provided as a convenience. NVIDIA disclaims any obligations to provide support, including bug fixes and security updates, and provides no warranty for this software.
Customers are responsible for root file system selection and support.
Before booting the target board, configure the root file system (rootfs) to:
• Set up the rootfs
• Copy it to the rootfs on the device
Step 1: Set Up the Root File System
This procedure uses the sample file system provided by NVIDIA as the base. If you wish to use your own file system, set the LDK_ROOTFS_DIR environment variable to point to the location of your rootfs and skip the steps for setting the root file system.
To set up the rootfs
1. Download the following file to your home directory:
This file contains the NVIDIA-provided sample root file system.
2. Extract the compressed file as follows:
• Navigate to the rootfs directory of the extracted NVIDIA driver package.
$ cd <your_L4T_root>/Linux_for_Tegra/rootfs
Where <your_L4T_root> is your L4T root directory, which is assumed to be your home directory (~).
• Extract the sample file system to the rootfs directory.
$ sudo tar -jxpf ../../Tegra-Linux-Sample-Root-Filesystem_<release_type>.tbz2
3. Run the apply_binaries.sh script to copy the NVIDIA user space libraries into the target file system.
$ cd ..
$ sudo ./apply_binaries.sh
4. If you are using a different rootfs, or if you have already configured your rootfs, apply the NVIDIA user space libraries by setting the LDK_ROOTFS_DIR environment variable to point to your rootfs. Then run the script, as shown above, to copy the binaries into your target file system.
If the apply_binaries.sh script installs the binaries correctly, the last message output from the script is “Success!”.
You have now completed setting up the root filesystem. Proceed to flash the rootfs onto the target SoC device.
Step 2: Copy the rootfs to the Device
Use these procedures to copy the file system to the SoC device.