NVUE Commands
This section shows you how to list all the NVUE commands and see help for the commands.
To view the NVUE command reference for Cumulus Linux, which describes all the NVUE CLI commands and provides examples, go to the NVUE Command Reference.
List All NVUE Commands
To see a list of all the NVUE nv show, nv set, nv unset, nv action, and nv config commands, run nv list-commands.
The following is only a small sample of the NVUE command list. To see the full and most up to date list of commands, run nv list-commands on your switch.
cumulus@leaf01:mgmt:~$ nv list-commands
nv show platform
nv show platform hardware
nv show platform hardware component
nv show platform hardware component <component-id>
nv show platform software
nv show platform software installed
nv show platform software installed <installed-id>
nv show platform capabilities
...
Show the NVUE Command Help
To see a description for a command, type the command with -h at the end:
cumulus@leaf01:mgmt:~$ nv set mlag backup -h
usage:
nv [options] set mlag backup <backup-ip>
Description:
backup Set of MLAG backups
Identifiers:
<backup-ip> Backup IP of MLAG peer (ipv4 | ipv6)
Output Options:
-o <format>, --output <format>
Supported formats: json, yaml, auto, constable, end-table, commands (default:auto)
--color (on|off|auto)
Toggle coloring of output (default: auto)
--paginate (on|off|auto)
Whether to send output to a pager (default: off)
General Options:
-h, --help Show help.
When you use -h, replace any variables in the command with a value. For example, for the nv set vrf <vrf-id> router pim command, type nv set vrf default router pim -h:
cumulus@leaf01:mgmt:~$ nv set vrf default router pim -h
usage:
nv [options] set vrf <vrf-id> router pim [address-family ...]
nv [options] set vrf <vrf-id> router pim [ecmp ...]
nv [options] set vrf <vrf-id> router pim [enable ...]
nv [options] set vrf <vrf-id> router pim [msdp-mesh-group ...]
nv [options] set vrf <vrf-id> router pim [timers ...]
Description:
pim PIM VRF configuration.
Identifiers:
<vrf-id> VRF (vrf-name)
Attributes:
address-family Address family specific configuration
ecmp Choose all available ECMP paths for a particular RPF. If 'off', the first nexthop found will be used. This is the default.
enable Turn the feature 'on' or 'off'. The default is 'off'.
msdp-mesh-group To connect multiple PIM-SM multicast domains using RPs.
timers Timers
Output Options:
-o <format>, --output <format>
Supported formats: json, yaml, auto, constable, end-table, commands (default:auto)
--color (on|off|auto)
Toggle coloring of output (default: auto)
--paginate (on|off|auto)
Whether to send output to a pager (default: off)
General Options:
-h, --help Show help.