Installation Instructions
The following illustrations show a 3700C system, yet all installation instructions apply to the SN3700 systems as well.
# | Illustration |
|---|---|
| 1 | Attach parts D and E (x2 of each) to the switch. Push the switch chassis’ pins through the slider key holes, until locking occurs. Pay attention to the rack’s type. Short Racks (430-580mm):
|
Standard Racks (580-800mm):  | |
2 | Short Racks: |
Standard Racks:
| |
| 3 | Install 8 cage nuts (B) in the desired 1U slots in the rack. |
| 4 | Do not tighten the screws yet. |
| 5 |
|
| 6 |
|
System Interfaces
Connector (Front) Side |
FRU (Rear) SideSN3700 |
* It may take up to five minutes to turn on the system. If the System Status LED shows amber after five minutes, unplug the system and contact your NVIDIA representative.
** Certain systems have a single management port.
LED Assignments
| Symbol | Description | Normal Status |
|---|---|---|
| System health | Green/Flashing |
| Fan health | Green |
| Power supply health | Green |
| Bad port detected | Off |
| Identifier LED | Off/Blue |
| Reset button | |
Configuration
- Connect the host PC to the Console (RJ-45) port.
Configure a serial terminal program.
Parameter
Settings
Baud rate
115200
Data bits
8
Stop bits
1
Parity
None
Flow control
None
Login:
OS
Username
Password
Onyx (MLNX-OS)
admin
admin
Cumulus Linux
cumulus
CumulusLinux! (case sensitive)
a. No login is required. Press Enter to activate the console.
Initial configuration
- Onyx (MLNX-OS): Go through the configuration wizard. For further information, please refer to: https://docs.nvidia.com/networking/category/mlnxos.
- Cumulus: By default, the MGMT port will acquire the IP from DHCP. You can cross reference the MAC of the switch with your DHCP server (MAC can be found on switch label) or using "ifconfig eth0" (when using MGMT0). For further information, refer to: https://docs.cumulusnetworks.com/display/DOCS/Quick+Start+Guide
For full installation instructions, go to https://docs.nvidia.com/networking/category/switchen.
