Installation and Configuration

The following illustrations show a 3700C system, yet all installation instructions apply to the SN3700 systems as well.

#	Illustration
1	Attach parts D and E (x2 of each) to the switch. Push the switch chassis’ pins through the slider key holes, until locking occurs. Pay attention to the rack’s type. Short Racks (430-580mm):
	Standard Racks (580-800mm):
2	Short Racks:
	Standard Racks:
3	Install 8 cage nuts (B) in the desired 1U slots in the rack.
4	Do not tighten the screws yet.
5
6

Connector (Front) Side
FRU (Rear) Side

* It may take up to five minutes to turn on the system. If the System Status LED shows amber after five minutes, unplug the system and contact your NVIDIA representative.

** Certain systems have a single management port.

LED Assignments

Symbol	Description	Normal Status
	System health	Green/Flashing
	Fan health	Green
	Power supply health	Green
	Bad port detected	Off
	Identifier LED	Off/Blue
	Reset button

1. Connect the host PC to the Console (RJ-45) port.

2. Configure a serial terminal program.

   Parameter	Settings
   Parameter	Settings
   Baud rate	115200
   Data bits	8
   Stop bits	1
   Parity	None
   Flow control	None

3. Login:

   OS	Username	Password
   Onyx (MLNX-OS)	admin	admin
   Cumulus Linux	cumulus	CumulusLinux! (case sensitive)

   a. No login is required. Press Enter to activate the console.

4. Initial configuration

1. 1. Onyx (MLNX-OS): Go through the configuration wizard. For further information, please refer to: https://docs.nvidia.com/networking/category/mlnxos.

   2. Cumulus: By default, the MGMT port will acquire the IP from DHCP. You can cross reference the MAC of the switch with your DHCP server (MAC can be found on switch label) or using "ifconfig eth0" (when using MGMT0). For further information, refer to: https://docs.cumulusnetworks.com/display/DOCS/Quick+Start+Guide

For full installation instructions, go to https://docs.nvidia.com/networking/category/switchen.