SIPL Camera
This reference application captures one VB1940 camera through Holoscan Camera’s
SIPLCaptureOp and displays its ISP NV12 output directly with Holoviz.
The HSB board is used through the UDDF driver loaded by SIPL; the application does not depend on
the Holoscan Sensor Bridge source repository.
Holoviz accepts the captured ImageT, including its plane offsets and row strides.
The display uses full-range BT.709, matching SIPL’s ISP output, without intermediate conversion
operators.
Before running the application, set up the HSB camera for SIPL and update the selected platform description with the connected board’s addresses. Host PTP must remain running in every capture mode; see the guide’s PTP setup.
Build and run
This reference path accepts the included 2560x1984 NV12 camera mode. Other dimensions require matching the application tensor and Holoviz bounds.
Shared VB1940 SIPL platform configurations are in
common/sipl/config.
Single-camera capture is the default. The stereo mode requests hardware synchronization, while
stereo_nosync lets both sensors run independently. Both modes use two capture operators sharing
one SIPL service, with each camera feeding its own display layer.
The cameras appear side by side. The preview displays each stream independently; it does not
pair frames or verify stereo synchronization. Direct executable use accepts --stereo with
the selected stereo JSON; --camera-index selects a camera only in single-camera mode.
Synchronized stereo capture has a known platform startup issue: both streams can stop delivering
frames within the first few seconds. Use stereo_nosync when synchronization is not required.
Run from Thor’s graphical session so Holoviz can create its Vulkan window. Close the window or press Ctrl+C to stop the camera cleanly.
Capture and display share one partition. Queue depth one with drop-oldest delivery keeps the preview current.