Debugging with Register Trace Buffers

You can use NVIDIA® Jetson™ RTRACE to determine what register access happened before a reset or panic. With RTRACE, kernel traces trigger read/write calls into a persistent register trace buffer that you can decode and dump after reboot, using the pstore file system.

RTRACE does not require ramdump. It prints parsed output from the device directly.

To enable RTRACE

  1. Add this setting to the kernel configuration:

    CONFIG_PSTORE_RTRACE=y

  1. Add this setting as well if you want to start RTRACE automatically:

    CONFIG_PSTORE_RTRACE_ENABLE_AT_STARTUP=y

To start and stop RTRACE

  • To start RTRACE, enter the command:

    $ echo 1 > /sys/kernel/debug/pstore/record_rtrace

  • To stop RTRACE, enter the command:

    $ echo 0 > /sys/kernel/debug/pstore/record_rtrace

Locating RTRACE Output

Output from RTRACE is available after reboot in the following file on the Jetson device:

/sys/fs/pstore/rtrace-ramoops

RTRACE output resembles this example:

0 R fe406314 <- c038df4c mem_serial_in+0x2c/0x38
0 R fe406314 <- c038df4c mem_serial_in+0x2c/0x38
0 R fe406314 <- c038df4c mem_serial_in+0x2c/0x38
0 R fe406314 <- c038df4c mem_serial_in+0x2c/0x38
0 W fe406304 <- c038df18 mem_serial_out+0x30/0x38