Bug Fixes History
For bug fixes prior to version 24.33.1048, please refer to the NVIDIA BlueField-2 DPU documentation.
|
Internal Ref. |
Issue |
|
3365411 |
Description: Fixed a link failure that occurred due to a wrong 'is_inphi_cable' indication. |
|
Keywords: Link failure |
|
|
Discovered in Version: 24.37.1300 |
|
|
Fixed in Release: 24.38.1002 |
|
|
3435583 |
Description: Under certain configurations, during the loading of the PXE driver in Smart-NIC mode, the firmware attempts to lock the CMAS resources in ICMC sets that are full. This results in the failure of the locking and raises a health buffer indication. To prevent the above scenario, in this firmware version we improved the distribution of resource locking in ICMC. |
|
Keywords: ICMC locking |
|
|
Discovered in Version: 24.37.1300 |
|
|
Fixed in Release: 24.38.1002 |
|
|
3331179 |
Description: Improved token calculation. |
|
Keywords: Token calculation |
|
|
Discovered in Version: 24.37.1300 |
|
|
Fixed in Release: 24.38.1002 |
|
|
3491841 |
Description: Fixed a firmware assert that occurred when tried to verify if the module supported "swap". |
|
Keywords: Firmware assert |
|
|
Discovered in Version: 24.37.1300 |
|
|
Fixed in Release: 24.38.1002 |
|
Internal Ref. |
Issue |
|
3432548 |
Description: Closed the attached QP doorbell to avoid any impact from the software side or the db_recovery mechanism |
|
Keywords: QP doorbell |
|
|
Discovered in Version: 24.35.2000 |
|
|
Fixed in Release: 24.37.1300 |
|
|
3385129 |
Description: Fixed an issue that resulted in high PTP offset by changing the RST value to 200, and adjusting the PTP Tx offset in PTP4L configuration. |
|
Keywords: PTP glitch, PTP constant offset |
|
|
Discovered in Version: 24.35.2000 |
|
|
Fixed in Release: 24.37.1300 |
|
|
3233113 |
Description: Disabled some HW optimization to prevent a HW race that caused an SQ to get stuck. |
|
Keywords: HW race, SQ |
|
|
Discovered in Version: 24.33.1048 |
|
|
Fixed in Release: 24.37.1300 |
|
|
3306318 |
Description: Fixed the issue that caused the virtio PXE boot to fail due to virtio BLK controller being stuck in continuous host warm reboot. |
|
Keywords: virtio full emulation, PXE boot, warm reboot |
|
|
Discovered in Version: 24.35.2000 |
|
|
Fixed in Release: 24.37.1300 |
|
|
3327847 |
Description: CNP received, handled, and ignored counters in the hardware counters cannot work after moving to Programmable Congestion Control mode. |
|
Keywords: CNP, Programmable Congestion Control |
|
|
Discovered in Version: 24.35.2000 |
|
|
Fixed in Release: 24.37.1300 |
|
Internal Ref. |
Issue |
|
3217896 |
Description: Fixed RDE PATCH operation status code reported in case the property is "read-only". |
|
Keywords: RDE |
|
|
Discovered in Version: 24.35.1012 |
|
|
Fixed in Release: 24.35.2000 |
|
|
3241357 |
Description: Fixed an issue in MCTP-over-PCIe, where the VDM message with the type Route-to-Root Complex, the target ID was not set as 0x0. |
|
Keywords: MCTP-over-PCIe, VDM message |
|
|
Discovered in Version: 24.35.1012 |
|
|
Fixed in Release: 24.35.2000 |
|
|
3250924 |
Description: Fixed an issue that resulted in NVMe driver not loading on a hotplug-able device when VIRTIO_EMULATION_HOTPLUG_TRANS was enabled by mlxconfig. |
|
Keywords: VIRTIO_EMULATION_HOTPLUG_TRANS, NVMe |
|
|
Discovered in Version: 24.35.1012 |
|
|
Fixed in Release: 24.35.2000 |
|
|
3215393 |
Description: Fixed an issue that caused the virtual QoS mechanism to stop traffic from reaching the full line rate of 200GbE on each direction when LAG was enabled. |
|
Keywords: Virtual QoS mechanism, 200GbE, LAG |
|
|
Discovered in Version: 24.35.1012 |
|
|
Fixed in Release: 24.35.2000 |