Installation and Configuration

1

Extract the system rail (Part A):

1. 1. Extract the system rail (Part A) from the rack rail (Part B).

   2. Press the spring latch, and pull the system rail out, as shown in the following illustration:

2

Mount the systems rails (Part A) onto the chassis:

1. 1. Attach the switch to the left and right system rails (Part A)

   2. Secure the assembly by pushing the chassis’ pins through the slider key holes, until a click is heard and locking occurs.

      

3

Install the rack rails (Part B) on the rack.

1. 1. Mount both of the rack rails (Part B) into the rack by angularly inserting the brakes located at the rails edges into the designated slots in the rack unit.

   2. Align both rack rails (Part B) to sit horizontally in parallel to the rack assembly.

      

   3. Pull the rack rails' telescopic extensions all the way to the rack's opposite side, and insert the latches at the rails' free edges to the rack's slots. A click should be heard as the spring latches are fully inserted and locking occurs.

      

4

Mount the chassis onto the rack.

1. 1. Slide the rails installed on the system into the channels in the rack rails.

      

   2. Tighten the captive screws on both sides to further secure the system to the rack's posts.

      

Connector (Front) Side

QM9700

QM9790

FRU (Rear) Side

* It may take up to five minutes to turn on the system.

If the System Status LED shows amber after five minutes, unplug the system and contact your NVIDIA representative.

** Certain systems have a single management port.

System health

Green/Flashing

Fan health

Green

Power supply health

Green

Identifier LED

Off/Blue

Reset button