Known Issues
The following sections describe known issues in this firmware release and possible workarounds.
|
Internal Ref. |
Issue |
|
2036930 |
Description: Degradation in throughput might be experienced when using HDR100 cables with a length of 30m and above. |
|
Workaround: N/A |
|
|
Keywords: Cables, Bandwidth |
|
|
Discovered in Version: 27.2000.2708 |
|
|
1996051 |
Description: After performing a software reset on the switch while using an Active Copper Cable or Optics Cable, the link gets high BER and is not available for traffic forwarding. |
|
Workaround: Toggle the Active Copper or Optics cables as the switch performs a reset. |
|
|
Keywords: Cables, BER |
|
|
Discovered in Version: 27.2000.2708 |
|
|
1972573 |
Description: Reading the Serial Number by the MSPS register is not functional on the new Delta PSU model. |
|
Workaround: N/A |
|
|
Keywords: Delta PSU model, MSPS register |
|
|
Discovered in Version: 27.2000.2708 |
|
|
1856717 |
Description: High BER may occur when connecting cables of type 0.5/1m DAC to an HDR speed. |
|
Workaround: N/A |
|
|
Keywords: Cables |
|
|
Discovered in Version: 27.2000.1886 |
|
|
1563590 |
Description: LR4 modules are currently not supported. |
|
Workaround: N/A |
|
|
Keywords: Modules/Cables |
|
|
Discovered in Version: 27.2000.1012 |
|
|
- |
Description: The supported length of HDR copper cables is currently up to 2M. |
|
Workaround: N/A |
|
|
Keywords: HDR cables |
|
|
Description: Although the effective BER (after FEC) is expected to meet our design targets (e.g. 10e-14 or lower), occasionally it may be higher. |
|
|
Workaround: N/A |
|
|
Keywords: Cables |
|
|
1796936 |
Description: HDR optical cables and Split cables support only HDR speed. |
|
Workaround: N/A |
|
|
Keywords: Link Speed, cables, Break-Out cables |
|
|
- |
Description: The following features are currently not supported on Mellanox Quantum™ based systems:
|
|
Workaround: N/A |
|
|
Keywords: Mellanox Quantum |
|
|
1970878 |
Description: When using Mellanox AOC cables longer than 50m use one VL to achieve full wire speed. |
|
Workaround: N/A |
|
|
Keywords: Cables |
|
|
955641 |
Description: VL_HIGH_LIMIT is not affecting the VL arbiter as expected. |
|
Workaround: Arbitration table should be set using only the low priority VL arbitration table. |
|
|
Keywords: VL Arbitration |
|
|
1249608 |
Description: Configuring weight "0" for VL, results in unexpected behavior. |
|
Workaround: Arbitration table should be configured with weights other than "0". |
|
|
Keywords: VL Arbitration |
|
|
- |
Description: Module info page in Diagnostics Data VS-MAD is not supported |
|
Workaround: N/A |
|
|
Keywords: Diagnostics Data VS-MAD |