NVIDIA Accelerated IO (XLIO) Documentation Rev 2.0.6
1.0

Running XLIO

In this page we show how to run a simple network benchmarking test and compare the running results using the kernel’s network stack and that of XLIO.

Before running a user application, you must set the library libxlio.so into the environment variable LD_PRELOAD. For further information, please refer to the XLIO User Manual.

Example:

Copy
Copied!
            

$ LD_PRELOAD=libxlio.so sockperf server -i 11.4.3.3

Warning

If LD_PRELOAD is assigned with libxlio.so without a path (as in the Example) then libxlio.so is read from a known library path under your distributions’ OS otherwise it is read from the specified path.

As a result, an XLIO header message should precede your running application.

Copy
Copied!
            

XLIO INFO : --------------------------------------------------------------------------- XLIO INFO : XLIO_VERSION: 2.0.6-1 Release built on Oct 31 2022 16:07:02 XLIO INFO : Cmd Line: sockperf server -i 11.4.3.3 XLIO INFO : OFED Version: MLNX_OFED_LINUX-5.8-1.0.1.1: XLIO INFO : --------------------------------------------------------------------------- XLIO INFO : Log Level INFO [XLIO_TRACELEVEL] XLIO INFO : ---------------------------------------------------------------------------

Followed by the application output, please note that:

  • The XLIO version is shown

  • The command line indicates your application’s name (in the above example: sockperf)

The appearance of the XLIO header indicates that the XLIO library is loaded with your application.

  • Check that ld is able to find the libxlio library:

    Copy
    Copied!
                

    ld -lxlio –verbose

  • Set UID bit to enforce user ownership:

    • RHEL:

      Copy
      Copied!
                  

      sudo chmod u+s /usr/lib64/libxlio* sudo chmod u+s /sbin/sysctl

    • Ubuntu:

      Copy
      Copied!
                  

      sudo chmod u+s /usr/lib/libxlio* sudo chmod u+s /sbin/sysctl

  • Grant CAP_NET_RAW privileges to application:

    Copy
    Copied!
                

    sudo setcap cap_net_raw,cap_net_admin+ep  /usr/bin/sockperf

  • Launch application under no root:

    Copy
    Copied!
                

    LD_PRELOAD=libxlio.so sockperf sr -i 10.0.0.4 -p 12345 LD_PRELOAD=libxlio.so sockperf pp -i 10.0.0.4 -p 12345 -t10

libxlio.so is limited to DEBUG log level. In case it is required to run XLIO with detailed logging higher than DEBUG level – use a library called libxlio-debug.so that comes with OFED installation.

Before running your application, set the library libxlio-debug.so into the environment variable LD_PRELOAD (instead of libxlio.so).

Example:

Copy
Copied!
            

$ LD_PRELOAD=libxlio-debug.so sockperf server -i 11.4.3.3

Warning

libxlio-debug.so is located in the same library path as libxlio.so under your distribution’s OS.

For example in RHEL8.x x86_64, the libxlio.so is located in /usr/lib64/libxlio-debug.so.

Warning

NOTE: If you need to compile XLIO with a log level higher than DEBUG run “configure” with the following parameter:

Copy
Copied!
            

./configure --enable-opt-log=none

© Copyright 2023, NVIDIA. Last updated on May 23, 2023.