Added:
Section “Changing Default Password”
Section “Account Service”
Section “Configuring BIOS Secure Boot”
Section “Configuring BIOS”
Page “Bare-metal Reprovisioning”
Section “Redfish Certificate Management”
The commands 0x32 0x97 and 0x32 0x98 to “NVIDIA Custom Commands”
Updated:
Note in section “Network Protocol Support”
Section “Boot Order Config”
Section “Installing BFB”
Section “BMC and CEC Firmware Update” and its subsections
Added:
Figure “NVIDIA® BlueField®-3 BMC Connector” to section “BMC Console Interface”
Section “SEL Messages”
Section “Updating BMC and Glacier Firmware with Vendor Field Mode” which is relevant for NVIDIA® BlueField®-3 DPU only
Page “Serial Redirect Mode”
Section “BlueField BMC Redfish Triggers”
Command 0x32 0x92 and 0x32 0x93 to “NVIDIA Custom Commands” table
Updated:
Section “BMC Management Interface” with new password requirements
Section “Sensor Data Record (SDR) Repository”
Link status codes to the p0_link and p1_link sensors in section “List of IPMI Supported Sensors”
Section “BMC and CEC Firmware Update”
Added:
Page “Vendor Field Mode”
Section “DPU Reset”
Updated:
Section “Boot Order Config” with note on DPU boot override setting
Updated:
NIC thermal sensors line in table under s ection “SDR Entry List”
Updated:
Page “NVIDIA OEM Commands”
Added:
New password policy to:
Warning box in section “BMC Management Interface”
Section “Boot Sequence Overview”
Step 3 in section “User Management”
-C 17 argument to IPMItool lanplus commands
Updated:
Section “User Management”
Section “Reset Control”
Updated:
Section “BMC Management Interface” by removing mentions of interface eth1
Page “NVIDIA OEM Commands”