Below are the bugs fixed in this version. For a list of fixes previous version, see Bug Fixes History.
| Internal Reference Number | Description |
|---|---|
3234066 | Description: When configuring IPsec full offload, after sending traffic for approximately 30 minutes, the traffic stops at some point and the connection gets lost. |
| Keywords: Steering, SMFS, Matcher Disconnect | |
Fixed in Release: 5.8-1.0.1.1 | |
3179535 | Description: SMFS will try to merge flow rules with the same matching criteria (as they share the same matcher) into one multi-destination rule. If merging fails, the matcher is disconnected by mistake. |
| Keywords: Steering, SMFS, Matcher Disconnect | |
Fixed in Release: 5.8-1.0.1.1 | |
3214198 | Description: ibv_reg_mr for huge pages was optimized in kernel >= 5.12 |
| Keywords: RDMA, ibv_reg_mr | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
2984134 | Description: Moving to SwitchDev mode while deleting namespace over Linux-6.0 can sometimes cause a deadlock. |
| Keywords: RDMA, SwitchDev | |
Discovered in Release: 5.5-1.0.3.2 | |
Fixed in Release: 5.8-1.0.1.1 | |
3106228 | Description: A net device validation issue prevented running IPv6 traffic using an RDMA communication manager between two interfaces on same host with same subnet. |
| Keywords: RDMA, IPv6, Communication Manager | |
Discovered in Release: 5.6-1.0.3.3 | |
Fixed in Release: 5.8-1.0.1.1 | |
3151843 | Description: In mlx5dv_mkey_check manpage, there is an inaccurate description of signature error handling flow. |
| Keywords: RDMA, manpage | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3229002 | Description: Creating and deleting MRs, caused a kernel slab cache leak issue. |
| Keywords: RDMA, Cache | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3236217 | Description: The rdma res show cm_id command does not list all cm_ids when some of them are in LISTEN state. |
| Keywords: RDMA, cm_ids | |
Discovered in Release: 5.0-1.0.0.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3146128 | Description: In older kernel version, PTP was not supported over VLAN interfaces. |
| Keywords: NetDev, PTP, VLAN | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
2969772 | Description: HW-GRO feature was blocked due to firmware limitations. |
| Keywords: NetDev, HW-GRO | |
Discovered in Release: 5.6-1.0.3.3 | |
Fixed in Release: 5.8-1.0.1.1 | |
3096393 | Description: STP packets failed to be transmitted. |
| Keywords: NetDev, STP | |
Discovered in Release: 5.5-1.0.3.2 | |
Fixed in Release: 5.8-1.0.1.1 | |
3236984 | Description: When using sysfs to read the hash function used to distribute the traffic between the TIRs (Transport Interface Receive), on occasion, the server crashed. |
| Keywords: NetDev, sysfs | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3126000 | Description: Upgrading from version 5.6-2 to 5.7 failed. |
| Keywords: Installation | |
Discovered in Release: 5.6-2.0.9.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3230524 | Description: Building with KMP enabled fails due to missing packages. OFED packages will now be built with KMP disabled. |
| Keywords: Installation, KMP | |
Fixed in Release: 5.8-1.0.1.1 | |
3158725 | Description: The script install.pl, used for (re)building kernel modules, used the name "kernel-source" as the package of the kernel-source on SLES systems. |
| Keywords: Installation, SLES | |
Discovered in Release: 5.6-1.0.3.3 | |
Fixed in Release: 5.8-1.0.1.1 | |
3142212 | Description: Starting firmware version xx.34.0350, a new NVCONFIG has been added to the ARM side only: MANAGEMENT_PF_MODE. If this config is on, the user will see a PCI Function (PF) which failed to probe: [ 6.837102] mlx5_core 0000:03:00.2: mlx5_cmd_check:756:(pid 206): ENABLE_HCA(0x104) op_mod(0x0) failed, status bad parameter(0x3), syndrome (0x6ca1f5) [ 6.864227] mlx5_core 0000:03:00.2: mlx5_peer_pf_init:40:(pid 206): Failed to enable peer PF HCA err(-22) [ 6.883453] mlx5_core 0000:03:00.2: mlx5_load:1129:(pid 206): Failed to init embedded CPU [ 8.261268] mlx5_core 0000:03:00.2: init_one:1365:(pid 206): mlx5_load_one failed with error code -22 [ 8.280056] mlx5_core: probe of 0000:03:00.2 failed with error -22 |
Keywords: Installation | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3174928 | Description: Using a 1-CPU system casues possible command flush deadlock. |
| Keywords: Core | |
Discovered in Release: 5.6-1.0.3.3 | |
Fixed in Release: 5.8-1.0.1.1 | |
3228721/3228357 | Description: An incorrect termination table was used with the uplink-to-uplink forward rule. |
| Keywords: ASAP2, eSwitch | |
Discovered in Release: 5.7-1.0.2.0 | |
Fixed in Release: 5.8-1.0.1.1 | |
3220120 | Description: In old kernels, when a VXLAN tunnel is set up on one OVS bridge and PF is up on another OVS bridge, traffic does not offload as expected. |
| Keywords: ASAP2, VXLAN | |
Discovered in Release: 5.4-3.0.3.0 | |
Fixed in Release: 5.8-1.0.1.1 |
