In the following menu, you can set the following options:
This section’s attributes are applicable only to Legacy mode.
| Location: | System setup/Port main configurations/iSCSI Configuration/iSCSI General Parameters |
| Description: | Controls booting to ISCSI target after connection. |
| Configurable: | Yes |
| Available options: |
|
| Location: | Main Configuration Form /iSCSI Configuration/iSCSI General Parameters |
| Description: | When the TCP/IP Parameters via DHCP is enabled, the initiator and target’s IP, netmask, gateway and DNS will be taken from DHCP instead of from the menu. |
| Configurable: | Yes |
| Location: | System setup/Port main configurations/iSCSI Configuration/iSCSI General Parameters |
| Description: | When iSCSI Parameters via DHCP are enabled, all the initiator and target’s parameters are taken from DHCP instead of from the menu. |
| Configurable: | Yes, if TCP/IP Parameters via DHCP is enabled. |
| Location: | System setup/Port main configurations/iSCSI Configuration/iSCSI General Parameters |
| Description: | Enables CHAP Authentication for iSCSI initiator. |
| Configurable: | Yes |
| Location: | System setup/Port main configurations/iSCSI Configuration/iSCSI General Parameters |
| Description: | Enables mutual CHAP authentication between the iSCSI initiator and target |
| Configurable: | Yes |
| Location: | System setup/Port main configurations/iSCSI Configuration/iSCSI General Parameters |
| Description: | Specifies whether IPv4 or IPv6 network addressing will be used for iSCSI initiator and targets |
| Configurable: | No |