Zero-Touch Provisioning Commands

nv show system ztp

	nv show system ztp Shows global ZTP status and the status for each section.
Syntax Description	N/A
Default	N/A
History	25.02.1884
Example	Copy Copied! admin@nvos:~$ nv show system ztp              operational        applied -----------  -----------------  -------- runtime      31s service      inactive source       dhcp-opt67 (eth0) state        enabled status       success config-save  disabled           disabled ZTP stages =============     Stage             Exit Status  Ignore Result  Runtime  Status     ----------------  -----------  -------------  -------  -------     02-startup-file   success    no             09s      success     03-commands-list  success    no             18s      success admin@nvos:~$ nv show system ztp              operational       applied -----------  ----------------  -------- runtime      05m 08s service      active-discovery state        enabled status       not-started config-save  disabled          disabled ZTP stages ============= No Data
REST API	GET https://<ip>/nvue_v1/system/ztp
Related Commands	nv set system ztp config-save
Notes

	nv set system ztp config-save {enabled \| disabled} Setting the ZTP configuration.
Syntax Description	enabled, disabled	Enables or disables “nv config save”
Default	Disabled
Configuration Mode	config
History	25.02.1884
Example	Copy Copied! `admin@nvos:~$ nv set system ztp config-save enabled admin@nvos:~$ nv config apply admin@nvos:~$ nv config save`
REST API	PATCH https://<ip>/nvue_v1/system/ztp
Related Commands	nv show system ztp
Notes	When ZTP is active, “nv config save” is suppressed because it may interfere with ZTP operation. Therefore, after running “nv set system ztp config-save enabled” and “nv config apply”, if “nv config save” is performed, then ZTP is disabled as a consequence of the database save.

	nv action {abort \| run} system ztp [force] ZTP action commands to interact with ZTP service.
Syntax Description	abort	Abort ZTP session. This command is used to interrupt ongoing ZTP session.
	run	Rerun ZTP flow. Use this command to manually restart a new ZTP session from scratch or from when it failed or aborted.
	force	This option is used to skip AYS dialog. By default, each action command asks the user to confirm the execution of the specified command.
Default	N/A
History	25.02.1884
Example	Copy Copied! admin@nvos:~$ nv action abort system ztp The operation will perform abort of the ZTP. Type [y] to perform abort of the ZTP. Type [N] to cancel an action. Do you want to continue? [y/N] y Action executing ... Aborting ZTP session Action executing ... Action succeeded admin@nvos:~$ nv action run system ztp The operation will perform rerun of the ZTP. Type [y] to perform rerun of the ZTP. Type [N] to cancel an action. Do you want to continue? [y/N] y Action executing ... Rerunning ZTP session Action executing ... Action succeeded
REST API	POST https://<ip>/nvue_v1/system/ztp
Related Commands	nv show system ztp
Notes	nv action abort system ztp command does not disable ZTP, in order to manually configure the device, please use "nv config save" first to fully disable ZTP process. nv action run system ztp command will overwrite any currently saved configuration file, make sure to backup the file in case required.