NVIDIA UFM-SDN Appliance User Manual v4.11.1
NVIDIA UFM-SDN Appliance User Manual v4.11.1

Prerequisites for UFM High Availability (HA) Installation

  • Reliable and high capacity out-of-band IP connectivity between the UFM Primary and Secondary UFM-SDN Appliance (1 Gb Ethernet is recommended). This connectivity is used for HA monitoring and replication of data and configuration.

  • In fabrics consisting of multiple tiers of switches, it is recommended that the InfiniBand ports of the primary and secondary UFM-SDN Appliance be connected to different fabric switches on the same tier (the outermost edge in CLOS 5 designs).

Procedure_Heading_Icon.PNG

To configure two appliances to run in High Availability (HA):

  1. Stop the UFM server on both machines.

    Copy
    Copied!
                

    ufm-appliance > enable ufm-appliance # configure terminal ufm-appliance [ mgmt-sa ] (config) # no ufm start

  2. Verify the UFM license is installed.

    Copy
    Copied!
                

    ufm-appliance [ mgmt-sa ] (config) # show ufm license

    If the license is not installed, please do so. For further information, please refer to the section "Obtaining the License".

  3. Configure both Appliances to run in HA configuration.

    Copy
    Copied!
                

    ufm-appliance [ mgmt-sa ] (config) # ufm ha configure <peer IP> <virtual IP> [interface]

Warning

You must run the “ufm ha configure” command from one of the machines, it is not required to run it on both appliances.

To return to a standalone configuration:

Procedure_Heading_Icon.PNG

  1. Stop the UFM server.

    Copy
    Copied!
                

    ufm-appliance > enable ufm-appliance # configure terminal ufm-appliance [ mgmt-ha-active ] (config) # no ufm start

  2. Verify the DRBD disk state is up-to-date on both appliances.

    Copy
    Copied!
                

    ufm-appliance [ mgmt-ha-active ] (config) # show ufm status

    Warning

    If the status is not synchronized, wait for a couple of more minutes and then run the “show ufm status” command.

  3. Disable High Availability configuration on both machines.

    Copy
    Copied!
                

    ufm-appliance [ mgmt-ha-active ] (config) # no ufm ha

© Copyright 2023, NVIDIA. Last updated on Sep 5, 2023.