Updating the PCIe Switches on the Motherboard Tray

1. Create a updparameters.json file with the following contents:

   {
       "Targets" :["/redfish/v1/UpdateService/FirmwareInventory/PCIeSwitch_0"]
   }
   

   Important

   Repeat this procedure for PCIeSwitch_1.

2. Update the firmware:

   nvfwupd -t ip=<bmc-ip-address> user=admin password=admin update_fw \
     -p nvfw_DGX_240918.1.0.fwpkg -y -s updparameters.json
   

   Example Output

   FW recipe: ['nvfw_DGX_240918.1.0.fwpkg]
   {"@odata.type": "#UpdateService.v1_6_0.UpdateService", "Messages": [{"@odata.type": "#Message.v1_0_8.Message", "Message": "A new task /redfish/v1/TaskService/Tasks/7 was created.", "MessageArgs": ["/redfish/v1/TaskService/Tasks/7"], "MessageId": "Task.1.0.New", "Resolution": "None", "Severity": "OK"}, {"@odata.type": "#Message.v1_0_8.Message", "Message": "The action UpdateService.MultipartPush was submitted to do firmware update.", "MessageArgs": ["UpdateService.MultipartPush"], "MessageId": "UpdateService.1.0.StartFirmwareUpdate", "Resolution": "None", "Severity": "OK"}]}
    FW update started, Task Id: 7
   Wait for Firmware Update to Start...
   Wait for Firmware Update to Start...
    TaskState: Completed
    PercentComplete: 100
    TaskStatus: OK
   Firmware update successful!
    Overall Time Taken: 0:00:09
   Refer to 'DGX H100 Firmware Update Document' on activation steps for new firmware to take effect.