Preparing the Motherboard for Service#

Before pulling the motherboard out of the system, the system must be shut down and cables must be removed from the system.

Caution

Wear an ESD strap during any procedure that involves touching electronic components.

  1. Shut down the system.

  2. To avoid misconfigurations, label all the cables before unplugging them.

    Label all network, monitor, and USB cables.

    _images/b200-rear-arrows.png

  3. Unplug all power cords.

  4. Unplug all network, monitor, and USB cables.

Release the Motherboard#

  1. Unlock the motherboard by loosening the captive screws that hold the ejection levers in place:

    _images/b200-captive-screws-loosen.png

  2. Pull the ejection levers to disengage the midplane connectors:

    _images/b200-chassis-rear.png

Insert the Motherboard#

  1. Use the levers to engage the midplane connectors:

    _images/b200-mb-levers-engage.png

  2. After the levers are fully closed, tighten the green thumbscrews to hold the ejection levers in place:

    _images/b200-mb-tray-screws.png

Finalize Motherboard Closing#

  1. Use the labels on the cables to reconnect them to the correct ports.

    _images/b200-rear-arrows.png

  2. Install all power cords.

  3. Power on the system.