Schedulers
The Scheduler component is a critical part of the system responsible for governing the execution of operators in a graph by enforcing conditions associated with each operator. Its primary responsibility includes orchestrating the execution of all operators defined in the graph while keeping track of their execution states.
The Holoscan SDK offers multiple schedulers that can cater to various use cases. These schedulers are:
Greedy Scheduler: This basic single-threaded scheduler tests conditions in a greedy manner. It is suitable for simple use cases and provides predictable execution. However, it may not be ideal for large-scale applications as it may incur significant overhead in condition execution.
MultiThread Scheduler: The MultiThread Scheduler is designed to handle complex execution patterns in large-scale applications. This scheduler consists of a dispatcher thread that monitors the status of each operator and dispatches it to a thread pool of worker threads responsible for executing them. Once execution is complete, worker threads enqueue the operator back on the dispatch queue. The MultiThread Scheduler offers superior performance and scalability over the Greedy Scheduler.
It is essential to select the appropriate scheduler for the use case at hand to ensure optimal performance and efficient resource utilization.
The greedy scheduler has a few parameters that the user can configure.
The clock used by the scheduler can be set to either a
realtime
ormanual
clock.The realtime clock is what should be used for applications as it pauses execution as needed to respect user specified conditions (e.g. operators with periodic conditions will wait the requested period before executing again).
The manual clock is of benefit mainly for testing purposes as it causes operators to run in a time-compressed fashion (e.g. periodic conditions are not respected and operators run in immediate succession).
The user can specify a
max_duration_ms
that will cause execution of the application to terminate after a specified maximum duration. The default value of-1
(or any other negative value) will result in no maximum duration being applied.This scheduler also has a boolean parameter,
stop_on_deadlock
that controls whether the application will terminate if a deadlock occurs. A deadlock occurs when all operators are in aWAIT
state, but there is no periodic condition pending to break out of this state. This parameter istrue
by default.When setting the
stop_on_deadlock_timeout
parameter, the scheduler will wait this amount of time (in ms) before determining that it is in deadlock and should stop. It will reset if a job comes in during the wait. A negative value means no stop on deadlock. This parameter only applies whenstop_on_deadlock=true
.
The multithread scheduler has several parameters that the user can configure. These are a superset of the parameters available for the GreedyScheduler (described in the section above). Only the parameters unique to the multithread scheduler are described here.
The number of worker threads used by the scheduler can be set via
worker_thread_number
, which defaults to1
. This should be set based on a consideration of both the workflow and the available hardware. For example, the topology of the computation graph will determine how many operators it may be possible to run in parallel. Some operators may potentially launch multiple threads internally, so some amount of performance profiling may be required to determine optimal parameters for a given workflow.The value of
check_recession_period_ms
controls how long the scheduler will sleep before checking a given condition again. In other words, this is the polling interval for operators that are in aWAIT
state. The default value for this parameter is5
ms.