Remove the ConnectX Card#

  1. Pull the card out of the slot:

    _images/dgx-h100-cx7-remove-card.png

  2. Before you pull the card too far, remove the white and black IPEX cables from the card.

    The white cable connects on top of the card and the black cable connects on the bottom (heatsink) of the card:

    _images/dgx-h100-cx7-ipex.png

  3. Follow the instructions in the next steps to remove and insert the IPEX connectors.

Remove an IPEX Cable#

Repeat this process for both white and black cables.

  1. Lift the locking door:

    _images/ipex-cable-2.png

  2. Push the cable away from the connector:

    _images/ipex-cable-3.png

Insert an IPEX Cable#

  1. Align the IPEX cable to the connector:

    _images/ipex-cable-4.png

  2. Press the cable into the connector:

    _images/ipex-cable-5.png

  3. Confirm the cable is in the connector:

    _images/ipex-cable-6.png

  4. Close the latching mechanism:

    _images/ipex-cable-7.png

  5. Make sure the cable is locked to the connector on the board:

    _images/ipex-cable-8.png

Install ConnectX Card#

  1. After you connect the IPEX cables, install the new card in the slot:

    _images/connectx-card-new.png

  2. Confirm the card is in place and that the cables are connected:

    _images/connectx-card-installed.png
On this page